Crushed Granite Driveways
We build new crushed granite driveways and rebuild worn ones across Leander and the Austin area. The grading and the base come with the job, and we replenish the granite when it shifts.
Learn More
Tar and chip seal is hot asphalt topped with a layer of chip stone. It gives a driveway or parking lot a textured stone finish. Pavement Solutions is an asphalt paving contractor in Leander. We lay chip seal for homes and businesses across the Austin area.
You choose the stone, and the stone sets the color of the finished surface. The texture gives tires grip on a sloped drive and on wet days. Once it sets, it is a low maintenance surface. A new chip seal driveway starts with driveway grading for a level, firm base.
Tell us about the driveway or parking lot and where it is. We look at the job and put a free quote in writing.
The base under a chip seal decides how well it bonds. On a new drive, the chip seal goes over a graded and compacted base. On an old paved drive, potholes and wide cracks get fixed first. Federal highway guidance calls for a clean, dry surface, with cracks over a quarter inch filled.
Then we spray a layer of hot asphalt emulsion. Chip stone goes down on top while the emulsion is still fresh. A vibratory roller presses the stone into the asphalt. The same guidance calls for the first roller pass within two minutes of the stone going down.
The stone matters too. Chip stone should be clean and close to one size. Dusty stone is one cause of chips that come loose.
Long rural driveways are the norm around Leander and out into the Hill Country. Chip seal covers that kind of drive with stone set in asphalt. Hill Country lots are often rocky and sloped, so grip on a grade counts. The state highway department notes that the stone adds texture, and the texture adds friction.
A chip seal is a surface layer, so it cannot fix a failed base. It should not go on pavement with structural damage. That kind of drive needs rebuilding before any new surface goes on.
Water is the other thing to settle first. Highway guidance calls for a drainage check before the work. If water pools on the drive or washes across it, driveway drainage work comes before the chip seal.
Chip seal is warm, dry weather work. Federal highway guidance sets the floor at 50 degrees and rising, for both the air and the pavement. It also calls for daylight hours and little or no chance of rain.
Texas highway crews count on the heat. The state highway department says the work goes best above 90 degrees. Heat helps the materials cure. Chip seal is the most used preventive treatment on Texas state highways.
The amount of asphalt matters too. Too little and the stone pulls loose. Too much and the asphalt bleeds up over the stone. Federal highway guidance traces both problems to the asphalt rate.
Call or text for a written quote. We work about 60 miles around Leander across Central Texas.
(512) 369-2450From the first call or text to the finished work, here is how it goes.
Call or text (512) 369-2450, or send the form. Tell us what needs work and where the property is.
We measure the area and check the surface that is there now. We also look at how water drains across it.
We put a free quote in writing. Once you say go, we set a work date with you.
We grade the ground and prepare the base for new paving. On worn asphalt, we mill or patch the bad areas first.
We pave with hot mix asphalt or lay the chip seal, then compact the surface. Sealcoating or striping comes last when the job calls for it.
Common questions about tar and chip seal around Leander and the Austin area. If yours is not here, call or text and ask.
We build new crushed granite driveways and rebuild worn ones across Leander and the Austin area. The grading and the base come with the job, and we replenish the granite when it shifts.
Learn More
We level and slope the ground so water flows away from your driveway. The grade goes in before any new surface goes down.
Learn More
We fix driveways and parking lots that hold water or wash out in hard rain. Swales and French drains move runoff off the pavement, and culverts carry ditch water under the drive.
Learn MoreBefore any paving work begins, we level and grade the surface so water flows away from it. That goes for driveways with hills and curves too.
Before we sealcoat, we clean the pavement and fill each crack by hand. We often recommend two coats of sealant.
We look at the job before we price it. Then the quote comes to you in writing.
Real reviews from real jobs, 23 reviews on Google.
Pavement Solutions did a wonderful job in asphalting our gravel driveway. Professional, courteous service at a reasonable price. We highly recommend them.
Pavement Solutions has been responsive and professional both times they have completed projects for me. I love the work they’ve done. Saving their number!! Highly recommend!!
We had it chip sealed and put chip seal around our barn for mud control and it looks fantastic and is very well done. The entire process was done so well. They are honest, hardworking, polite, great price and do great work. Someone you can trust.

Chip seal vs asphalt for a Texas driveway: national cost ranges, grip on slopes, upkeep and lifespan, and when each one fits a Central Texas drive.
Read more →
What does an asphalt driveway cost in Texas? Published Austin area and national ranges per square foot, plus what moves the price on your driveway.
Read more →Tell us about the job with the form, or call or text (512) 369-2450. We get back to you and set a time to look at it.
Tell us about the driveway or parking lot and where it is. We look at the job and put a free quote in writing.